The experience in the past few days has been terrible:
In the first week, I was not asked to go to work immediately, but was familiar with the environment there (the small factory lacked special training). Then, because I lacked social experience and did not understand the rules, I took pictures of the situation in the factory and sent them to Tiktok. The local supervision department saw the situation and asked for on-site inspection and rectification on the grounds of potential safety hazards in the factory. Afterwards, the factory found my video and requested it to be deleted, while also warning me not to post any further information about the situation inside the factory, as it may reveal trade secrets, etc. Fortunately, they saw that I was new and did not give me any more serious punishment.
I was visiting and studying on the lathe over there when I was splashed with cutting fluid from the lathe on my face. Fortunately, it did not cause any allergies or other problems. The reason why digital CCD lathes have not been fully adopted is because the CCD lathes over there are unable to process hard materials with a large amount of processing. Therefore, in this situation, it is necessary to first use a manual lathe to cut out a rough shape, and then quenching the results before using CCD precision machining.
Speaking of this, it suddenly occurred to me that I could add a fluid input slot to the lathe in the game for inputting cutting fluid or something (just like what I did with a magnetic separator). Although it may not be useful in the game, it can be used to something Tweaks.